207 ACCESS STAIRCASES- TECHNICAL INFORMATION - 2023 STAIRCASES •From the staircase, fix the tether hook into a stirrup 1.00 m above the landing. •To ensure operator safety, remove/refit 2 safety ledgers 1.50 m towards the central side on this level. •Fit the 4 guardrails of the 2nd landing and the next uprights. •Fit the last ledgers and diagonal braces. •Assemble the stringers on the 5th and 6th flights. •Bolt the steps and risers from the bottom upwards and fit the guardrails at an angle. •Anchor points of the last 2 sides (anchors on 2 standards). 10 11 12 Follow the assembly and dismantling recommendations presented at the beginning of the technical information. Dismantle in the reverse order of assembly. P.P.E. P.P.E. P.P.E. KIT FOR A STAIRCASE 1.00 M WIDE: - 16 PANACIERs measuring 1.00 m x 0.30 m, - Three 1.00 m normal ledgers. KIT FOR A STAIRCASE 2.00 M WIDE: - 24 PANACIERs measuring 2.00 m x 0.30 m, - Three 2.00 m normal ledgers. ASSEMBLY KIT KIT FOR A STAIRCASE 1.50 M WIDE: - 16 PANACIERs measuring 1.50 m x 0.30 m, - Three 1.50 m normal ledgers. Repeat steps 6 to 10 as required, according to the height of the staircase. •Remove the assembly decks located under the last flights. •Use these decks to construct the last landing, adding a 0.20 m Panacier. •From the staircase, fix the tether hook into a stirrup 1.00 m above the landing. •Fit the guardrails on the last landing and upright stiffeners at each standard end. •Lay plywood on all the landings. •Inspect the staircase and put the inspection report in the pocket on the “no entry” sign. 13 14 15 P.P.E. P.P.E. P.P.E. The personal protective equipment must be attached on the MULTICRAB at least 1.00 m above the deck on which the operator is working, either around a ledger or through a stirrup. The stirrups at deck level must on no account be used for attaching. One of the two hooks of the fall prevention system must constantly be attached (except when accessing the upper floor). •Depending on the load factor, the standards on public staircases are either with uprights from the MULTICRAB range, or with uprights in the CRABÉTAI range. •For public staircases 1.50 m wide, the central support ledger of the Panaciers must be a reinforced 1.50 m ledger. •For public staircases 2.00 m wide, all the support ledgers of the Panaciers must be reinforced 2.00 m ledgers.
RkJQdWJsaXNoZXIy OTQ2MzM=